Slides: Room Extension and Retraction

Level and stabilize the vehicle prior to extending the room, check for clearance.   Set Park Brake. Ignition Key must be “on”. Best to run the engine but not required.

Open a window or door before extending the room.

The room cannot extend if the Excess Slope light is on.

Extend Room. On the room extension, turn Key to “ON”. 

The amber indicator light will light when it is ready to operate the slide (bladder seal is indicated to be deflated). Takes about 40 seconds after turn slide key.

When the amber light comes on, operate the slide.  

Turn key off after the slide extends and bladder inflates.

Retract Room*. Turn the key ON and the amber light will come on when the bladder is emptied. 

It is then ready to Retract…BUT  hold the Retract switch down until the Red Light goes out.  

Then the key may be turned counterclockwise to “off”

The seal will inflate when the KEY is turned “off”.

*Rain: If the awning is wet, it is best to tilt the coach and drain water from the slide and awning.

Note: If either side of the room stops moving, release the Room Control Switch immediately. Do not reverse.  Contact HWH. 

Note: The motorhome will not go into gear if the room is not fully retracted but if it is a false signal, you can over-ride by going to the bay with the pump and turn the servo to “220”. Use a screwdriver, top right-hand corner of the bay.

Note: The HWH 2000 CAN system is a computerized modular network that controls all leveling systems and the room extensions. Certain functions only work if the ignition is the ON position or when any room extension control panel key is ON. The network will remain active for 10 minutes after the ignition key and all room extension control panel keys have been turned OFF.