Doors: Bay Door Handle

by TrimarkCorp

010-0600 Flush Mounted Pop-up T-Handle This handle was designed for toppers, liftgate and baggage doors where 1/4 turn cam locking is desired. It features a low profile handle that pops-up when actuated for ease of use and is available in several rotations, drives bar lengths and finishes.

A close up of a device

Description automatically generated

Designed For Toppers and liftgate doors, garage doors, storage, and access doors

Any application where low profile hardware is important Features/Benefits Flush-mounted – when “T” handle is depressed, rivets and fastener heads are concealed

Rubber gasket under base provides resistance to water infiltration

Available Key lockable with 50 key codes available or keyed alike.

Non-locking version is also available 1, 2, or 3-point locking 90° or 150° rotation 2.500″ (63.5mm) or 3.500″ (88.9mm) drive bar lengths Clockwise or counterclockwise rotation

MATERIAL:

Shuttered keyway: stainless steel

All major components: zinc alloy

Drive bar: zinc plated steel

Internal (2) springs: stainless steel

FINISH: Black powder coated or white

030-0450 2-Point Paddle Handle

This flush mounted paddle was designed for compartment doors entrance doors for the RV and specialty vehicles. It features 2-point remote pivot plate actuation, is power lockable and can be used in FMVSS 206 applications.

This product is being replaced by the 030-1450. We do not recommend the use of this product in new applications. For additional information, please contact Customer Service at 1-800-447-0343.

This flush mounted paddle is a redesign of our 030-0450 paddle handle for compartment doors and entrance doors on RV and specialty vehicles. Containing the same proven mechanical details as previous with a modernized look, it can be used in FMVSS 206 applications, is power lockable and features 2-point remote pivot plate and lock cam actuation.

Material

Sturdy zinc die-cast alloy housing and paddle

Steel components: Zinc plated, mild steel

The handle is easy to install with a single 1/4-20 UNC nut and supplied mounting bracket (Mounting torque not to exceed 30 in-lbs [3.39 N-m])

Either handed version can be installed in a wide range of locations in either horizontal or vertical orientations (left hand shown)

Retrofits with most 030-0450 flush paddle handles